I have pulled apart the front axle of a 14g grader. The weight bearing thrust and seal surfaces, between the where the wheel tilt yoke and the steering knuckle meet, in the area you would call the upper ball joint which is actually a pin, it is tore up because of bearing failure. The problem is the parts are hard to find used that don't need this repair and very expensive new. The local cat dealer machine shop said they would have 3 days to repair each piece. Has anyone out there been successful with repairing these parts? how? My SIS needs an update to show me graphics if someone else will post it the axle arrangement is 2g8800.....TIO:confused:
↧