Hi everyone! I'm a newbie to the forum and also to the Galion motor grader. The 118B that I just acquired is blowing the leaning control valve boot. The manual says that there maybe a kink/obstruction in the drain line from the hydraulic control manifold. The drain line looks OK back to the tank. I did notice that a flex line was installed just prior to the tank. If this flex line doesn't have the same ID as the OEM hard line could this be causing the problem? The front tires did seem to lean without input after traversing uneven ground. Could my problem be in the leaning cylinder or maybe even the control valve? Any and all information that could be shared with me will be greatly appreciated! I did look in the motor grader post but didn't find this specific issue. Thanks for your Time!
↧